Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
)URQW+RXVLQJ$VVHPEO\9&9&9&79&7
Front Housing Assembly
V24C/V26C & V24CT/
V26CT
5HPRYLQJWKH)ODW3DQHO%DFNOLJKW7XEH
:LWKRXWIXOO\GLVDVVHPEOLQJWKH)URQW+RXVLQJ
 Remove the Front Housing Assembly.
 Disconnect the large flex cable from Display Driver Board and remove the flex circuit
connector from Flat Panel Display.
 Disconnect the 3-wire backlight cable from the end of the Converter Board.
 Remove the Flat Panel Display Assembly.
 Turn the Flat Panel Display onto a clean flat surface with display side up.
 Remove the two screws (securing the flat panel to the flat panel bracket) at the end nearer
to you.
 /RRVHQthe two screws at the other end.
 Gently lift the near end of the Flat Panel.
 Using your fingernail or a small flat-bladed screwdriver, press the tiny black clip holding
the backlight in its channel.
 By gently tugging on the 3-wire connector, slide the backlight out from its channel.
,I)URQW+RXVLQJLVIXOO\GLVDVVHPEOHG
 Carefully place the Flat Panel with display side down on a clean flat surface.
 Using your fingernail or a small flat-bladed screwdriver, press the tiny black clip holding
the backlight in its channel.
 By gently tugging on the 3-wire connector, slide the backlight out from its channel.
Do not touch fluorescent tube when removing or installing the backlight as oil from
fingerprints will shorten the operating life of the tube.
Now continue the disassembly procedure on page 9-24.
127(