Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
)URQW+RXVLQJ$VVHPEO\9&9&9&79&7
Front Housing Assembly
V24C/V26C & V24CT/
V26CT
5HPRYLQJWKH)ODW3DQHO'LVSOD\$VVHPEO\
)LQJHUSULQWVDQGGLUWEHWZHHQWKH)ODW3DQHO'LVSOD\DQGSODVWLFDQWLJODUHVFUHHQVKRZ
XSSURPLQHQWO\GXULQJLQVWUXPHQWRSHUDWLRQ7DNHFDUHQRWWRWRXFKWKH)ODW3DQHO
VFUHHQRUWKHLQVLGHRIWKHFOHDUSODVWLFDQWLJODUHVFUHHQ5HPRYHDQ\ILQJHUSULQWVRUGLUW
XVLQJDQRQUHVLGXHIRUPLQJFOHDQHUVXFKDVDOFRKRODQGDOLQWIUHHFORWK
 Remove Front Housing Assembly (see page 9-2).
 It is not necessary to completely remove the Board Shield to remove the Flat Panel Dis-
play Assembly. Just remove the two screws located in the narrow channel and the two
hex stand-off screws (see VWHS,"Removing the Board Shield" on page 9-13). If you
already removed the Board Shield, proceed to the next step.
 Gently lift up on the Flat Panel Bracket containing the Flat Panel and remove it from the
Front Housing.
5HPRYLQJWKH%RDUG$VVHPEO\
To remove the flat panel it is not necessary to remove the 3-Board Assembly.
The 3-Board Assembly consists of the DSPC Board, CDCI Board, and Flat Panel Adapter
Board.
 Remove the Board Shield.
 Remove the two screws securing the ferrite block and wide Flex Cable to the Flat Panel
Bracket.
 Carefully disconnect the flex cable connector (do not pull on the flex cable); then gently
lift the ferrite block and flex cable off the threaded studs on the Flat Panel Bracket.
&$87,21
127(