Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
5HSDLULQJWKH$JLOHQW0RGHO9&79&7
Repairing the Agilent
Model V24CT/V26CT
5HPRYLQJWKH3RZHU6XSSO\$VVHPEO\
$3RZHUOHDNDJHWRJURXQGPD\RFFXUGXHWRGLUW\FDEOHFRQQHFWRUV7KHSRZHUVXSSO\
FDEOHFRQQHFWRUVVKRXOGEHYHULILHGIRUFOHDQOLQHVVDIWHUUHPRYLQJDQGEHIRUHUHSODFLQJ
WKHSRZHUVXSSO\
%<RXVKRXOGSHUIRUPWKHOHDNDJHFXUUHQWWHVWGHVFULEHGLQ&KDSWHUZKHQHYHU
UHPRYLQJDQGUHSODFLQJWKHSRZHUVXSSO\$JURXQGIDXOWPD\RFFXUFDXVLQJDXVHU
VDIHW\FRQFHUQ
 Turn power off to the instrument and disconnect the AC power cord.
 Remove Lead Acid Batteries (see 9-5)
 Remove the Front Housing Assembly (see 9-2).
 Disconnect all cables from the System Board as shown
If your power supply assembly is defective and your unit contains option J13, you need to
remove the RS232 cable and install it in the replacement assembly using the same cable
routing path. See “Replacing Power Supply Assembly” on page 9-15.
&$87,216
1
2
3
4
5
6
7
8
9
10
11
3
System Board interface
connectors:
1. Keypad connector
2. Flat Panel Data Connector
3. 5V and 12V power
supply connector
4. Service ports (not cabled)
5. SDN interface cable
6. Defib sync connector
(not cabled)
7. Front-end link connector
8. Speaker connector
9. 60 VDC power supply
connector
10. RS232 connector (with
option J13)
11. Contrast Adjust Cable
1RWH