Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
,QWURGXFLQJWKH$JLOHQW996HULHV
Introducing the Agilent
V24/V26 Series
)ODW3DQHO$GDSWHU%RDUG
The Monochrome Model V24 Flat Panel adapter board provides an interface between the
monochrome Flat Panel display assembly and System Board. The board contains the
backlight inverter assembly, Flat Panel bias and contrast/brightness circuitry.
)LJXUH)ODW3DQHO$GDSWHU%RDUG
3RZHU6XSSO\
The Agilent V24/V26 Series power supplies convert input power into three DC voltages for
the mainframe and for the plug-in modules in the plug-in rack.
The Model V24CT/V26CT can operate from an internal battery power supply, or from an
external AC source. The internal power is provided by two rechargeable, removable batteries.
The batteries are 12 Volt, 2.3 Amp-Hour, sealed lead acid batteries. The battery’s rate of
discharge is dependent on the number and type of modules being used with the monitor.
The batteries are charged while the monitor is plugged in to an external AC source. Depleted
batteries should be charged as soon as possible. When using the external AC source, the
recharge time takes approximately 4 hours to a 90% capacity if the monitor is off. If the
monitor is on, the charge time takes considerably longer (approximately 16 hours). An
alternative method for recharging the batteries is to remove the batteries from the monitor
and charge them using the Agilent M1278A External Battery Charger. The M1278A charges
up to 4 batteries at a time and reduces the charge time to 2.5 hours.
Flat Panel Adapter Board