Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
5HSDLULQJWKH$JLOHQW0RGHO9&9&
Repairing the Agilent
Model V24C/V26C
5HSODFLQJWKH6\VWHP%RDUG
 Insert the System Board into the Rear Housing.
 Replace the 5 screws securing the System Board to the Rear Housing.
 If the System Board was replaced, reprogram the Flash Memory. Refer to “Upgrade and
Cloning Instructions” on page 2-31.
 Insert the service port cover into the Rear Housing.
 Connect the cables from the System Board System Board as shown at the top of the page.
 Reinstall the Front Housing Assembly.
6
7
8
1
2
3
4
5
9
10
System Board interface
connectors:
1. Keypad connector
2. Flat Panel Data Connector
3. 5V and 12V power
supply connector
4. Service ports (not cabled)
5. SDN interface cable
6. Defib sync connector
(not cabled)
7. Front-end link connector
8. Speaker connector
9. 60 VDC power supply
connector
10. RS232 connector (with
option J13)
6HUYLFH
3RUW
&RYHU