Specifications

5-44 Troubleshooting Plug-in Modules
$JLOHQW0$996HULHV6HUYLFH*XLGH
Troubleshooting Plug-
in Modules
7LQM 0C + 0.1C
3HUIRUPLQJWKHWFS2

WFS&2

0RGXOH6HOI7HVW
$XWR&KHFN The check is performed automatically when the system is switched on, during
calibration, and continuously when no transducer is connected. When the auto check fails, the
INOP message: Equipment Malfunction is given (refer to the Troubleshooting Chapter in
this manual for troubleshooting details).
6HOI7HVW: The tcpO
2
/tcpCO
2
module self-test may be performed at any time. The test signal lasts
about 30 seconds and then the display returns to the normal monitoring mode.
7(67 Press
5(68/7 If the module is functioning correctly, the following numerics are displayed
without the alarms being activated:
WFS2
60 mmHg (8.0 kPa)
WFS&2
40 mmHg (5.3 kPa)
&$87,21 5DGLDWHGLPPXQLW\,IRSHUDWLQJXQGHUFRQGLWLRQVDFFRUGLQJWR(1XSWR9P
HOHFWULFDOILHOGVWUHQJWKWKHIROORZLQJGHYLDWLRQVLQWKHPHDVXUHPHQWVFRXOGRFFXUWFS2

PP+JRUOHVVWFS&2
PP+JRUOHVV,WLVUHFRPPHQGHGWRDYRLGWKHXVHRIHOHFWULFDOO\
UDGLDWLQJGHYLFHVLQFORVHSUR[LPLW\WRDWFS2 WFS&2 PRQLWRU
3HUIRUPLQJWKH&2

0RGXOH6HOI7HVW
$XWR&KHFN None.
6HOI7HVW The self-test may be performed at any time. The test signals last about 30 seconds, and
then the display returns to the normal monitoring mode.
7(67 If a transducer is connected to the module, the following conditions must be met:
• The motor in the transducer is running.
• No heater malfunction is reported.
Press .
5(68/7 If the module is functioning correctly the values will be displayed without the
alarms being activated and should read as follows:
(7&2
40 mmHg (6.0kPa)
,0&2
0 mmHg (0.0kPa)
7KLVPRGXOHRQO\
GLVSOD\VQXPHULFV
0RQLWRU6HWXS
7HVW6LJQDOV
7KLVPRGXOHRQO\
GLVSOD\VDQXPHULF
7KHVLPXODWHG&2
ZDYHLVSURYLGHGRQ
WKHGLVSOD\ZLWKWKH
QXPHULFV
0RQLWRU6HWXS
7HVW6LJQDOV