Specifications
Troubleshooting Plug-in Modules 5-37
$JLOHQW0$996HULHV6HUYLFH*XLGH
Troubleshooting Plug-
in Modules
Troubleshooting VueLink Module Problems
127( For detailed troubleshooting information on the VueLink module, please refer to the
documentation delivered with your external device driver.
For general testing of the VueLink module the following test procedure can be performed:
0$9XH/LQN7HVWVXVLQJ9XH/LQN7HVW0RGXOH
The VueLink Test Module (part number M1186-60510) is a plug-in module used to test M1032A
VueLink modules in the Agilent V24/V26.
7HVW3URFHGXUH
The following steps are the procedure for testing a VueLink module using the VueLink Test
Module. In order to run the test, the Test Module must be preselected ON in Config Mode. This
means that the Test Module must be one of the devices made available for selection during
configuration of the VueLink Module.
The test itself is carried out in Monitoring Mode. For information concerning the configuration of
VueLink modules see the M1032A VueLink Module Handbook (part number M1032-9000B).
6WHS Plug the VueLink module into the module rack on the V24/V26.
6WHS Press the Setup key on the front of the VueLink module.
6WHS Press .
6WHS In the window that appears, select “Test Module” using the softkey. It
is important to note which device driver was previously selected, in order to be able to
reset it at the end of the test. (It will be labeled on the front of the VueLink Module.)
6WHS Press to store the selection and wait for the message “Switched
to new device”.
6WHS Plug in the Test Module.
6WHS Connect the modules by plugging one end of the cable (part number M1032-61661) into
the connector on the front of the VueLink Module, and the other end into the connector
on the front of the Test Module.
6WHS Press to make the Test Module Task Window appear on the screen.
Note: The key is hollow and therefore cannot be selected.
6HOHFW'HYLFH
1H[W'HYLFH
Confirm
6HWXS9XH/LQN
6FDOH:DYH