Specifications

5-34 Troubleshooting Plug-in Modules
$JLOHQW0$996HULHV6HUYLFH*XLGH
Troubleshooting Plug-
in Modules
6HOI7HVW3URFHGXUHVIRU%,6FRPSRQHQWV
3,&'6&7HVW
7(67 In Monitoring mode connect the 6HQVRU6LPXODWRU (for maximum usage please
refer to the documentation delivered with the Sensor Simulator) to the Patient
Interface Cable (for part number please refer to Table 6-16 on page 6-25).
Enter the BIS Task Window by pressing , followed by
.
Start Impedance Check by pressing . This brings up the BIS
Cyclic Check Task Window. Check the displayed results.
5(68/76 PIC and DSC are functioning correctly and the test is passed, if the following
results are displayed:
If the test fails, firstly replace PIC with a known good one. Perform test again. If
it fails again, DSC is faulty and has to be replaced.
127( If the DSC/PIC Test alternately passes and fails, this indicates a broken DSC cable. In this
case you have to replace the DSC.
'6&6HOI7HVW
If the correct functioning of the DSC is in doubt, perform the DSC self-test.
127( The DSC and long cable only are covered by this test, not the short cable (which can be
tested by the PIC/DSC Test described above).
This test is not available directly after connecting the DSC. Wait at least 10 seconds until
the DSC has stabilized.
Do not run this test while electrocautery equipment is in use. This will cause a failure.
7(67 Enter Service Mode
Enter the BIS Self-Test Task Window by pressing ,
followed by .
Start Test by pressing .
(OHFWURGH ([SHFWHG9DOXH
14-6 k
28-12 k
31-3 k
0RGXOH6HWXS
%,6
6WDUW&KHFN
0RGXOH6HWXS
%,6
7HVW'6&