Specifications

5-24 Troubleshooting Plug-in Modules
$JLOHQW0$996HULHV6HUYLFH*XLGH
Troubleshooting Plug-
in Modules
Troubleshooting Blood Analysis Problems
This section describes how to troubleshoot and correct faults associated with the Blood Analysis
plug-in module. The procedures for recognizing, isolating, and correcting faults with this module
are as follows:
• Identifying a problem based on repeated INOPS.
• Checking the Blood Analysis task window for specific error messages and performing the
corrective actions suggested in the table given with this module.
7R7URXEOHVKRRWWKH0RGXOH
❏ If you are XQDEOHWRDFFHVVWKH%ORRG$QDO\VLVPRGXOH7DVN:LQGRZ, perform the
following actions:
6WHS Make sure the Blood Analysis parameter is turned on. Turn it on, if it is not.
6WHS Make sure you don’t have more than one Blood Analysis module plugged into the
module racks you are using. If more than one Blood Analysis module is plugged in,
the supernumerary modules are ignored and should be removed.
6WHS Check the connection on the module and the rack interface.
 Unplug and re-plug the Blood Analysis module and check if the 2 green LEDs
on the Blood Analysis module light up after re-plugging. If they do not,
proceed with the following:
 Put the Blood Analysis module into another slot and check the LEDs once
again. If they light up now, the connector for the previous slot is faulty and the
rack needs to be replaced. If they do not, proceed with the following:
 1RWHWKLVSURFHGXUHDSSOLHVRQO\IRUVHWXSVLQZKLFKWKH%ORRG$QDO\VLV
PRGXOHLVORFDWHGLQD6DWHOOLWH5DFN,IWKLVGRHVQRWDSSO\IRU\RXUVLWXDWLRQ
SURFHHGZLWK
Replace the cable from the Satellite Rack to the function box. Again unplug
and re-plug the Blood Analysis
module and check if the LEDs light up. If they
do not, proceed with the following:
 Plug any other (not faulty) module into the same slot and check if the LEDs
light up. If the LEDs of the alternative module light up, the Blood Analysis
module is defect and has to be replaced. If it does not, either the rack or the
rack interface card is defect. Proceed with the following:
 Replace the rack and plug in the Blood Analysis module into the new rack. If
the LEDs on the module do not light up, replace the rack interface card in the
function box.