Specifications
$JLOHQW0$996HULHV6HUYLFH*XLGH
8VLQJ6XSSRUW )XQFWLRQV
Using
Support Functions
Additional lines are displayed below the device line when a device is assigned to a central
station (as in the previous example). This does not signify that the central station is physically
connected to the same branch as the device.
When a device is assigned to a central station, the letter “C” or “R” is displayed between the
UNIT and REL columns for the central station.
• A C indicates that the device is also assigned to an arrhythmia system.
• An R indicates that recordings can be made at the central station.
&ROXPQ5(/
Displays the protocol release of each device on each branch.
&ROXPQ(55
Lists hexadecimal error codes for each device on the network. If the code is “00”, no errors
are present. Otherwise, interpret the error codes as follows:
Convert the two-digit hexadecimal error code to an eight-digit binary code.
Compare the resulting binary code with the error code chart below: Note the extreme left
digit of the binary code is digit number “7”, the second from the left is number “6”, and
so on. Each “1” in the binary code corresponds to an error.
7DEOH%LQDU\&RGH(UURU&KDUW
'LJLWV (UURU,QGLFDWHG
7 6 5 4 3 2 1 0 ;
1 . . . . . . . False SPS Event Flag
1 . . . . . . Fatal Control Error Flag
1 . . . . . Recoverable Control Flag
Error
1 . . . . Physical Data Error Flag
1 . . . Logical Data Error Flag
1 . . Poll Cycle Overflow Flag
1 . Command Response Fail Flag
1 System Cycle Failure Flag