Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
8VLQJ6XSSRUW )XQFWLRQV
Using
Support Functions
&KDQJLQJWKH*OREDO6ZLWFKHV
The Global Switches facility can be used to change the global configuration of the system.
The global configuration is the same for all configuration sets.
To enter the Global Switches task window:
 Press the hardkey.
 Press the softkey.
 Select item by pressing arrow key and highlight selection.
 Press to change configuration.
 Change the global configuration of the system as required.
 Press
 Press to store new settings
/LQH)UHTXHQF\
The line frequency indication is used to switch between 50 Hz and 60 Hz for the ECG
filtering frequency.
(QVXUHWKDWWKH/LQH)UHTXHQF\LVVHWFRUUHFWO\IRUWKHFRXQWU\RSWLRQRUGHUHG7KH
IDFWRU\GHIDXOWLV+]IRUDOOXQLWV
6HWWLQJV7UDQVIHU
The patient-related settings of each parameter module can be stored in the EEPROM of the
modules. During monitoring, changes in the active settings are recognized and saved. This
allows the module to retain all settings, even if transported from one system to another. The
Settings Transfer feature can be configured to ‘‘Yes’’ or ‘‘No’’.
The parameter module stores its settings in its EEPROM until they are changed, either by
modifying them in the parameter task window, or by resetting all parameter settings to user-
configured default values while in Monitoring Mode. All parameter settings are reset to the
user defaults when doing one of the following:
• Changing Operating Mode by pressing , then
and then the softkey.
• Changing the Configuration Set by pressing and then the
softkey.
Both actions result in a “Restart”, in which the instrument is rebooted and the user default
settings of the parameter module are stored in the EEPROM of the module.
Monitor Setup
*OREDO6ZLWFKHV
&KDQJH&RQWHQW
6WRUH6HWWLQJV
Confirm
&$87,21
Monitor Setup
0RUH&KRLFHV
2SHUDWLQJ0RGHV
Monitor Setup
&RQILJ6HWV
127(