Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
8VLQJ6XSSRUW )XQFWLRQV
Using
Support Functions
7R8VH(UURU&RGHV
Access the Status Log:
 From any of the operating modes, press the Hardkey.
 Press the softkey.
 Use the ARROW keys to move the highlighting to the softkeys that include
.
 Press the softkey. The screen displays the Status Log.
Once in the Status Log, check it for entries that have an H, W, C, or F entered in their first
field. This identifies fatal errors. We are only concerned with fatal errors because these are
the errors which are significant enough to affect the Monitor operation. Each fatal error
shows you the following:
a. The subsystem which has reported the fault,
b. The part number of the subsystem,
c. The device ID code which indicates the hardware device or software piece which the
caused the fault,
d. The error code describing the fault identified.
e. The date and time the fault occurred.
This is important because the status log contains the fourteen most recent occurring errors,
with the most recent errors at the bottom. If you have more than one error message for a
single incident, deal with the first occurring error message (error messages are list
chronologically by date and time) before dealing with the others pertaining to the incident. It
is a good practice to erase the Status Log after you have dealt with or recorded all the errors
shown.
8VLQJ6WDUWXS(UURU&RGHV
If your Monitor is re-starting repeatedly, a start-up error code may appear at the top of the
screen. The start-up error code gives information similar to that displayed in the status log,
except the start-up error codes are listed in hexadecimal notation. These codes are identified
by an “H” at the end of the code.
Start-up Error Messages require the same corrective action as the error messages found in the
status log. The Error Code Listings at the end of this module contain the hexadecimal
equivalent for each error code and device ID.
(UURU&RGH/LVWV
The first table gives the error code listing for device ID 16400 (4010H). The next table gives
the error code listing for all other device error code. Each error code entry provides the
following information:
Monitor Setup
0RUH&KRLFHV
6WDWXV/RJ
6WDWXV/RJ