User`s guide

196 Chapter 9
Tw o -To n e Wav e fo rm Ge ne r at or
Creating, Viewing, and Modifying Two-Tone Waveforms
Figure 9-1 Spectrum Analyzer Setup
To C re ate a Two-Ton e Wave fo rm
This procedure describes how to create and a basic, center- aligned, two- tone waveform.
1. Preset the signal generator.
2. Set the signal generator RF output frequency to 20 GHz.
3. Set the signal generator RF output amplitude to 0 dBm.
4. Press
Mode > Tw o Ton e > Freq Separation > 10 > MHz.
5. Press
Tw o To n e O f f O n to On.
6. Turn on the RF output.
The two- tone signal is now available at the signal generator RF OUTPUT connector. Figure 9-2 on
page 197 shows what the signal generator display should look like after all steps have been
completed. Notice that the T-TONE, I/Q, RF ON, and MOD ON annunciators are displayed and the
parameter settings for the signal are shown in the status area of the signal generator display.