User`s guide

68 Chapter 3
Setting Measurement Conditions
Setting Channels and Traces
IF bandwidth √
- IF Bandwidth
Calibration √
Marker
√ (
*3
)
Analysis
Fixture simulator
√ (
*4
)
-
Fixture Simulator
Time domain √
- Gating
- Transform
Parameter conversion √
- Conversion
Limit test √
- Limit Test
Saving and recalling data √
Macro √
System
Printing/Saving display
Screen/Beeper/GRIB settings/Network
Settings/Date & Time/Key
Lock/Backlight/Firmware
Revision/Service menu
√
Preset
√
*1.Hold All Channels for the analyzer.
*2.Auto Scale All and scale Divisions must be set up in rectangular form for each channel.
*3.Turning the marker table display on or off applies to the entire analyzer. On the other hand, the sweep range setting
of the marker must be performed for each channel. In the preset condition, marker coupling is enabled and marker
settings and movements are effective for all traces on a channel.
*4.The balanced-unbalanced conversion function (
BalUn ON/OFF) must be turned on or off for each trace.
Table 3-2 Parameters and setup items they control
Parameter Controlled Setup Items Setup Key(s)
Analyzer Channel Trace