User`s guide

640 Appendix C
List of Default Values
List of Default Values, Save/Recall Settings, and Backup Settings
Frequency Offset
External Source
LO Frequency
OFF ←←√ K/C
Multiplier 0.0000 ←←√ K/C
Divisor 1.0000 ←←√ K/C
Offset 0.0000 Hz ←←√ K/C
Start 0.0000 Hz ←←√ K/C
Stop 0.0000 Hz ←←√ K/C
Control OFF ←←√ K/C
Power -10 dBm ←←√ K/C
Slope
[xxdB/GHz]
0 dB/GHz ←←√ K/C
Slope [ON/OFF] OFF ←←√ K/C
Avoid Spurious OFF ←←√ K/C
X-Axis Normal
(When Frequency Offset is set off.)
←←√ K/C
Response
(When Frequency Offset is set on.)
←←√ K/C
Continuous Continuous (Ch1)
Hold (Ch2 to 9)
← Hold
(all channels)
√ K/C
Trigger Source Internal ←←√ K/C
Trigger Event On Sweep ←←√ K/C
Trigger Scope All Channel ←←√ K/C
Ext Trig Delay 0.0000 s ←←√ K/C
Low Latency OFF ←←√ K/C
Marker 1 Marker 1 is turned on immediately
after the marker softkey menu is
displayed.
←←√ K/C
Ref Marker Mode OFF ←←√ K/C
Peak
Peak Excursion
3.0000 dB ←←√ K/C
Peak Polarity Positive ←←√ K/C
Target
Target Value
0.0000 dB
(When Target is selected)
←←√ K/C
Target Transition Both
(When Target is selected)
←←√ K/C
Tracking OFF ←←√ K/C
Key Operation Factory-shipped Setting Default Value Save/
Recall
Backup Available
Means of
Defining a
Setting
*RST