User`s guide

Appendix A 609
Manual Changes
Manual Changes
A. Manual Changes
Change 4
The firmware revision A.03.54 or below does not support the following functions. Please
delete the descriptions about these functions in this manual.
o Auto Power Range set function
Change 3
The equipments that firmware revision at the factroy shipment is A.03.53 or below is not
eligible for the following specs. support the following functions. Please refer to original
attached manuals about them.
o Initial Source Port Control function
Change 2
Figure 16-4 dimensions of rear view was changed. Eligible serial numbers are
MY42100211 (for E5070B), MY42100407 (for E5071B) and later. For the earlier serial
number equipment, please refer to original attached manuals.
Change 1
The firmware revision A.03.0x does not support the following functions. Please delete the
descriptions about these functions in this manual
o User Characterized ECal
o Confidence check on calibration coefficients using ECal
o 4-port network embedding/de-embedding (Fixture simulator)
300 kHz to 3 MHz
(source power level = +10 dBm)
0.035 ° rms (23°C±5°C, typical)
0.05 ° rms (high temperature
mode: ON, typical)
3 MHz to 4.25 GHz
(source power level = +10 dBm)
0.007 ° rms (23°C±5°C, typical)
0.02 ° rms (high temperature
mode: ON, typical)
4.25 GHz to 6 GHz
(source power level = +8 dBm)
0.021 ° rms (23°C±5°C, typical)
0.035 ° rms (high temperature
mode: ON, typical)
6 GHz to 7.5 GHz
(source power level = +6 dBm)
0.021 ° rms (23°C±5°C, typical)
0.035 ° rms (high temperature
mode: ON, typical)
7.5 GHz to 8.5 GHz
(source power level = +6 dBm)
0.035 ° rms (23°C±5°C, typical)
0.05 ° rms (high temperature
mode: ON, typical)
*1.Trace noise is defined as a ratio measurement of a through, at IFBW = 3 kHz.
Table A-7 Test Port Input (Trace Noise)
Description Specification Supplemental Information