User`s guide

ManualsBrandsAgilent Technologies ManualsMultimeterENA Series

601

602

603

604

605

606

607

608

609

610

598 Appendix A

Manual Changes

Figure A-9 Example of performing multiport TRL/LRM calibration

Step 5. Press the

Reflection button (4 in Figure A-9).

Step 6. Connect the Reflection standard to test port 1 and press the

[ ]Reflection1 button. The

reflection measurement is performed, and an asterisk appears at the

[ ]Reflection1 button.

Step 7. Connect the Reflection standard to test port 2 and press the

[ ]Reflection2 button. The

reflection measurement is performed, and an asterisk appears at the

[ ]Reflection2 button.

Step 8. Connect the Reflection standard to test port 3 and press the

[ ]Reflection3 button. The

reflection measurement is performed, and an asterisk appears at the

[ ]Reflection3 button

and then a check mark [v] also appears on the

Reflection button.

Step 9. Press the

Match button (5 in Figure A-9).

Step 10. Connect the Match standard to test port 1 and press the

[ ]Match1 button. The match

measurement is performed, and an asterisk appears at the

[ ]Match1 button.

Step 11. Connect the Match standard to test port 2 and press the

[ ]Match2 button. The match

measurement is performed, and an asterisk appears at the

[ ]Match2 button.

Step 12. Connect the Match standard to test port 3 and press the

[ ]Match3 button. The match

measurement is performed, and an asterisk appears at the

[ ]Match3 button and then a

check mark [v] also appears on the

Match button.

Step 13. Press the

Line1 button (6 in Figure A-9).

Step 14. Connect the Line 1 standard between test ports 1 and 2 and press the

[ ]Line1 1-2 button.

The line measurement is performed, and an asterisk appears at the

[ ]Line1 1-2 button.

Step 15. Connect the Line 1 standard between test ports 1 and 3 and press the

[ ]Line1 1-3 button.

The line measurement is performed, and an asterisk appears at the

[ ]Line1 1-3 button and

then a check mark [v] also appears on the

Line1 button.

Step 16. Press the

Line2 button (7 in Figure A-9).

Step 17. Connect the Line 2 standard between test ports 1 and 2, and press the

[ ]Line2 1-2 button.