User`s guide

490 Chapter 15
Measurement Examples
Measuring the SAW Bandpass Filter Using the Segment Sweep
Measuring the SAW Bandpass Filter Using the Segment
Sweep
This section illustrates how to use the segment sweep function to evaluate a SAW bandpass
filter with a center frequency of 947.5 MHz.
Evaluation Steps
Here, the DUT is evaluated by following the steps described in Table 15-1.
Table 15-1 Evaluating the DUT Using the Segment Sweep
Step Description
“1. Determine the Segment Sweep
Conditions” on page 491
The segment sweep conditions are determined according to the
characteristics of the DUT.
“2. Create a Segment Sweep Table”
on page 492
The segment sweep conditions are entered in the E5070B/E5071B.
“3. Select the Segment Sweep as the
Sweep Type” on page 494
The segment sweep is selected as the sweep type.
“4. Execute the Calibration” on
page 494
A 2-port ECal is performed between the test ports connecting the
DUT.
“5. Connect the DUT” on page 495 The DUT is connected.
“6. Execute the Measurement” on
page 495
A trigger is applied to perform the measurement.
“7. Define the Setup for Display” on
page 495
The choice is made between frequency base and order base as the
method of displaying segments.