User`s guide

Chapter 13 429
Setting and Using the Control and Management Functions
Setting the GPIB
13.Setting and Using the
Control and Management
Functions
Figure 13-1 USB/GPIB Interface Detected dialog box
Step 2. Confirm that VISA Interface Name is set to GPIB0 (1 in Figure 13-1) and SICL Interface
Name is set to hpib7 (2 in Figure 13-1) and then click the Accept button (3 in Figure 13-1).
If the setting is correct, the procedure is complete. If the setting is different, click the
Edit
button (4 in Figure 13-1).
Step 3. The USB to GPIB Configuration dialog box (Figure 13-2) appears. Make the setting
enclosed in the thick lines in Figure 13-2 (1 in Figure 13-2) according to the figure and then
click the
OK button (2 in Figure 13-2).
Figure 13-2 USB to GPIB Configuration dialog box
If you need to check/change the setting of the USB/GPIB interface after connecting the
USB/GPIB interface, follow these steps:
Step 1. Press .
Step 2. Press
Misc Setup.
Step 3. Press
GPIB Setup.
Step 4. Press
System Controller Configuration.