User`s guide

Chapter 9 345
Analysis in Time Domain (Option 010)
Transformation to time domain
9. Analysis in Time Domain
(Option 010)
Setting display range
The E5070B/E5071B has the following limitations on the display range you can set.
Lower limit −
*1
Upper limit
*1
The number of response points displayed on the graph is the same as the number of points
regardless of the response resolution.
Operation
Step 1. Press (or ) and (or ) to activate the trace for
which you want to set the display range.
Step 2. - Press
Transform to display the “Transform” menu.
Step 3. Press each of the following softkeys and then specify the display range. At the side of the
set value in the data entry bar, the distance corresponding to the set time is displayed
(Figure 9-7). The displayed distance is a value taking the velocity factor into consideration.
NOTE You cannot use hardkeys to set the display. The hardkeys are dedicated to specifying the
sweep range.
Figure 9-7 Data entry bar
Enabling transformation function
Operation
Step 1. Press (or ) and (or ) to activate the trace for
which you want to use the transformation type.
Step 2. - Press
Transform to display the “Transform” menu.
Step 3. Press
Transform to enable (ON) the transformation function.
*1. is the measurement range expressed in time obtained in “Measurement range” on
page 343.
T
span
T
span
T
span
Softkey Function
Start Sets the start value of the display range in time
Stop Sets the stop value of the display range in time
Center Sets the center value of the display range in time
Span Sets the span of the display range in time