Manualshelf

User`s guide

ManualsBrandsAgilent Technologies ManualsMultimeterENA Series
281282283284285286287288289290
Chapter 6 281
Data Analysis
Using the Equation Editor
6. Data Analysis
Enabling/Disabling the equation editor
The following procedure describes how to enable/disable the equation entered using the
equation editor.
Step 1. Press or to activate the channel for which you want to use the
equation editor.
Step 2. Press or to activate the trace for which you want to use the equation
aditor.
Step 3. Press .
Step 4. Press
Equation.
Entering the equation label
You can enter an equation label using the equation editor. After inputting, the measurement
parameter of the active trace is displayed on the screen as the equation label (Figure 6-19).
By entering the equation label and “=” prior to the equation, it is recognized as the equation
label.
For the procedure to start the equation editor, refer to “Procedure to start the equation
editor” on page 279.
NOTE A space is not available for the equation label.
The following figure is the example of the equation label, “myTr”.
Figure 6-19 Entering the equation label
Softkey Function
ON Enables the equation editor.
OFF Disables the equation editor.