User`s guide

Agilent EasyEXPERT User’s Guide Vol. 1, Edition 1 1- 79
Main GUI
Configuration
Host Host name of the B1500
Refresh Refreshes the event log.
Extended Configuration
Not available for the B1505A. This dialog box opens by clicking the Extended
Configuration button in the Configuration window’s Switching Matrix screen and
closes by clicking the Close button.
Save as Hardware
Profile
Switching matrix hardware configuration can be saved as the hardware profile.
Save Saves the present hardware profile.
The hardware profile can be made for each workspace individually.
CMU
Compensation
Selects the compensation mode of the capacitance measurement using the switching
matrix. Click one of the radio buttons, No Compensation, Select, and User
Compensation Data File. See Agilent B1500A User’s Guide for the capacitance
compensation when the switching matrix is used.
• No Compensation
Select this radio button if you do not need the capacitance compensation. The
raw data without compensation is displayed and saved.
• B2200A/B2201A (standard)
The following setup is available for the B2200A/B2201A hardware profile.
• Select
Select this radio button to perform the capacitance compensation for the path
from the B2200A/B2201A input ports to Agilent 16495F/G connector plate
or Agilent B2220A probe card interface. The data after compensation is
displayed and saved.
DUT I/F Specifies the model number of the path you use. The
selections are the 16495F/G and B2220A.
Cable Specifies the model number of the cable from the
B2200A/ B2201A output to the DUT I/F. The selections
are the 16494A/B/C-001 (1.5 m) / 002 (3 m) / 005 (4 m).
This mode cannot perform the capacitance compensation for the cables to
positioner/manipulator or the probe card.
• User Compensation Data File