User`s guide

1- 74 Agilent EasyEXPERT User’s Guide Vol. 1, Edition 1
Main GUI
Configuration
Table 1-4 N1265A Status Indicator and Selector Connection Path
Thermometer Channel 1 Enables/disables the thermometer channel 1.
Channel 2 Enables/disables the thermometer channel 2.
Interval Specifies the interval of the temperature measurement. During
executing any classic test, the temperature is not measured
regardless of this setting.
Format Specifies the record format of the temperature data. The data is
recorded by adding to the end of the Device ID string. Variables
{0} for the channel 1 temperature, {1} for the channel 2
temperature, and {2} for the difference between {0} and {1}
are available for setting the format.
Initial setting: T1={0}, T2={1}, T1-T2={2} deg C
You can use the measurement temperature values as the repeat measurement
condition. See
“Repeat Measurement Setup” on page 1-50.
Auto Detection This check box is used to enable/disable the automatic detection of the N1265A. If
this box is checked, the automatic detection is performed when EasyEXPERT is
launched.
Status
indicator
Selector Output terminals
a
a. In the normal state, the selector makes the path to the output port from the input port specified
by the Default field. When a measurement is performed, the selector performs automatic switch
-
ing in every test. The selector makes the path to the output port from the measurement resource
used for the test.
Low Sense Low Force High Sense High Force
(off) Open Open Open Open
GNDU Sense GNDU Force Open Open
SMU GNDU Sense GNDU Force SMU Sense SMU Force
UHC UHCU Low Sense UHCU Low Force UHCU High Sense UHCU High Force
HVSMU
GNDU Sense GNDU Force HVSMU Force Open
GNDU Sense GNDU Force HVSMU Force
+ Series resistor
Open