User`s guide

1- 50 Agilent EasyEXPERT User’s Guide Vol. 1, Edition 1

Main GUI

Repeat Measurement Setup

This dialog box is opened by clicking the Repeat button, and is used to set the repeat

measurement condition. This dialog box supports the following action buttons.

Run Starts measurement.

Abort Aborts the measurement.

Cancel Cancels performing the repeat measurement and closes this

dialog box.

The repeat measurement is performed as shown in Figure 1-3. The repeat

measurement operation is controlled by the value of Count and status. Where, Count

is the number displayed in the Count field of the main screen, and status must be a

parameter of the response created by Start Procedure and Iteration Procedure. For

the response, see

Figure 1-4.

Figure 1-3 Repeat Measurement Execution Flow

Repeat

Procedures

This area is used to specify the procedure to be called while the repeat measurement

is performed. The procedure must be the execution file (.exe file). If no procedure is

needed, empty the field. The Browse button opens a file browser.

status

limit

Abort

If Abort is clicked

Yes

Start

Start Procedure

Iteration Procedure

Final Procedure

End

Test Execution

Yes

status= True ?

Yes

Count >= limit

status= True ?

Count=Count+1

Count=0

Count is set to 0 when repeat measurement is started.