Manualshelf

User`s guide

ManualsBrandsAgilent Technologies ManualsBusiness equipmentEasyEXPERT
21222324252627282930
Agilent EasyEXPERT User’s Guide Vol. 1, Edition 1 1- 13
Main GUI
Main Screen
Help menu Provides the following three functions.
About This Instrument... Opens the Configuration window.
About This Test... Opens the test description dialog box.
Agilent EasyEXPERT Help Opens the EasyEXPERT help window.
Application Test This tab selects the application test mode of EasyEXPERT. For details of the
graphical user interface in this mode, see
“Application Test” on page 1-29.
Classic Test This tab selects the classic test mode of the EasyEXPERT. For details of the
graphical user interface in this mode, see
“Classic Test Definition” on page 2-1.
Tracer Test This tab selects the tracer test mode of EasyEXPERT. For details of the graphical
user interface in this mode, see
“Tracer Test” on page 1-31.
Quick Test This tab selects the quick test mode of the EasyEXPERT. For details of the graphical
user interface in this mode, see
“Quick Test” on page 1-48.
Data Display Opens “Data Display (page 1-84)” used to display the test result data. EasyEXPERT
always handles the test setup corresponding to the Data Display window now active
or most recently activated.
Calibration Opens “Calibration (page 1-58)” used to see the self-calibration results, to perform
the self-calibration, or to perform the current offset cancel.
Configuration Opens “Configuration (page 1-64)” used to see the module configuration, to see the
self-test results, to perform self-test, to establish the GPIB connection with Agilent
B2200A/B2201A/E5250A switching matrix, or to see the event log.
Switching Matrix Not available for the B1505A. Opens “Switching Matrix Operation Panel (page
1-81)” used to control Agilent B2200A/B2201A/E5250A switching matrix.
Standby Opens “Standby Channel Definition (page 1-83)” used to set the standby channel
which is the channel to keep the specified output when the standby mode is ON and
in the non-measurement state.
Single Triggers a single measurement. To abort measurement, click Stop button that
appears instead of the Single button.