User`s guide
Agilent EasyEXPERT User’s Guide Vol. 1, Edition 1 3- 21
Application Test Definition
Test Contents
Debugging Test Contents
On the Test Contents tab screen, click the Debug tab. The following buttons will
appear. They are useful for debug of your test contents.
Set the break point, and click the Run button. And check the operation of the test
contents, the value of variables by using the Variable Inspector, and so on.
Figure 3-6 Debugging Test Contents
Run/Pause This button starts the debug (executes the test flow). During execution, the label
changes to Pause. Clicking Pause pauses the execution, and changes the label to Run
that is used to continue the debug (execution).
Abort This button aborts the debug (execution).
Step This button executes the selected line of the test flow. Clicking the button repeatedly
continues the execution by a line.
Break This button sets/releases the break point. For the break point, this button releases the
break point from the selected line. Program execution will break at the break point
automatically.
Inspect This button is available when the debug (execution) is paused or broken. This button
opens the Variable Inspector used to monitor value of device parameters, test
parameters, analysis parameters, local variables, or system variables. See
“Variable
Inspector” on page 3-22.
%UHDNSRLQW
3DXVHGSRLQW