User`s guide

3- 8 Agilent EasyEXPERT User’s Guide Vol. 1, Edition 1
Application Test Definition
Test Specification
SMU, HPSMU, HCSMU, DHCSMU (dual HCSMU),
HVSMU, HRSMU, MPSMU, MCSMU, HRSMU/ASU,
GNDU, SPGU, HVSPGU, WGFMU, RSWGFMU, MFCMU,
MFCMU/SCUU, SWM IN, SWM
AUX IN, SWM SMU IN,
UHCU500, UHCU1500, UHVU, or HVMCU
Dimension... For Vector parameters.
Opens the Define dimensions dialog box for defining the
dimension of vector data.
Use Dim1Min and Dim1Max to specify the primary dimension
of vector data. This direction can be for the primary sweep data.
Use Dim2Min and Dim2Max to specify the secondary
dimension of vector data. This direction can be for the
secondary sweep data.
The following conditions must be satisfied.
•1 Dim1Min Dim1Max (ex. Dim1Min=1,
Dim1Max=11)
•1 Dim2Min Dim2Max (ex. Dim2Min=1,
Dim2Max=3)
Assign Output
Channels...
For ALWaveform parameters.
This button opens the Assign ALWaveform Output Channels
dialog box which specifies the variables if they are used to
identify the SPGU channels. The variables must be the Module
type test parameter.
For example, when the parameters are defined as shown below,
PG1 should be set to the Assign ALWaveform Output Channels
dialog box for the WAVE1 parameter.
PG1: Module parameter to identify the SPGU channel
WAVE1: ALWaveform parameter for the PG1 setup data
Use “Define ALWG Waveform Window (page 2-68)” to create
the SPGU ALWG setup data. For the above example, the PG1 is
the SPGU channel identifier when creating the WAVE1 data.