User`s guide

2- 58 Agilent EasyEXPERT User’s Guide Vol. 1, Edition 1
Classic Test Definition
Advanced Setup Window for C-V Sweep
After Measurement
Settings
This area sets the bias hold function used to keep the source output after
measurement. The source applies the specified bias between a measurement and the
next measurement performed in the repeat measurement or quick test. See
“Bias
Hold Function” on page 4-41.
Bias Hold after
Measurement
Bias hold function ON or OFF
Output Value after
Measurement
Source output value after measurement
START (sweep start value) or STOP (sweep stop value)
Semiconductor
Relays (16440A
SMU/PG Selector)
Effective only for the instrument installed with SPGU or PGU. Agilent 16445A
selector adapter is needed for connecting Agilent 16440A SMU/PGU selector
(B1500A-A04).
This area sets the selector CH1/CH3 status (DEFAULT or PGU OPEN). To use this
function, set the DEFAULT setting to Always SMU or Normally PGU (AUX) by
using the SMU/PG Selector tab screen on the Configuration window before starting
the SPGU output.
CH1 CH1 status, DEFAULT or PGU OPEN.
CH3 CH3 status, DEFAULT or PGU OPEN.
CH1 represents channel 1 on the first selector and CH3 represents channel 1 on the
second selector. See
“SMU/PG Selector” on page 4-49 for details on the selector.