User`s guide

Agilent EasyEXPERT User’s Guide Vol. 1, Edition 1 2- 35

Classic Test Definition

Direct Control

CH3 CH3 status, DEFAULT or PGU OPEN.

CH1 represents channel 1 on the first selector and CH3 represents channel 1 on the

second selector. See

“SMU/PG Selector” on page 4-49 for details on the selector.

Primary Setup

Primary setup is the initial setting set for when the Direct Control test is started. This

setting is different from the initial setting set by the device clear or the *RST

command. The differences are listed below.

• Data output format

FMT 13, 0 is set.

• Program memory

Setup is not changed. The last used setting is retained.

• Internal variables

Setup is not changed. The last used setting is retained.

• Measurement condition setup commands

Setup is not changed for the following commands. The last used setting is

retained.

WV, WI, WSV, WSI, WNX

PV, PI, PWV, PWI

BDV

QSV, QSO

LGI, LGV, LSI, LSV, LSSI, LSSV

BGI, BGV, BSI, BSV, BSSI, BSSV

FC, WDCV

PDCV, PWDCV

WFC

WA CV

MDCV