User`s guide

2- 28 Agilent EasyEXPERT User’s Guide Vol. 1, Edition 1
Classic Test Definition
C-V Sweep
Measurement Setup
This setup screen is used to set the MFCMU measurement mode, source channel
outputs, the sweep abort condition, and the measurement time.
C-V (VAR1) This area defines the MFCMU measurement mode and DC bias output.
V Name Variable name of the DC bias output data
Model MFCMU measurement mode. Primary and secondary
measurement parameters. See
Table 4-2 on page 4-21. Select
one from the pull-down menu.
para1 Name Variable name of the primary measurement parameter
para2 Name Variable name of the secondary measurement parameter
Direction Sweep direction, single (start to stop) or double (start to stop to
start)
Linear/Log Sweep output, LINEAR, LOG10, LOG25, or LOG50. where
the number following LOG means the number of sweep points
in one decade.
Start Sweep start value
Stop Sweep stop value
Step Incremental step value of the sweep output
Compliance Only for SMU. Compliance value. Enter the current limit value
for the voltage source, or the voltage limit value for the current
source.
No of Step Number of steps. The value is automatically calculated by using
the start, stop, and step values.
Signal Source This area defines the measurement signal.
Frequency List Frequency of the measurement signal
F Name Variable name of the frequency data
AC Level Oscillator level of the measurement signal, 10 mV to 250 mV, 1
mV resolution
Add Adds a measurement frequency.
Delete Deletes the selected frequency. To select the frequency, use the
left radio button.