User`s guide

Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1 7-19
Utilities
Utility Programs
Utility Programs
The following useful programs are stored in the following folder. Remember that
they are just sample programs.
<program folder>\Agilent\B1500\EasyEXPERT\Utilities\
• “Prober Control”
• “sleep.exe”
•“XSLT”
<program folder>\Agilent\B1500\EasyEXPERT\415xC\Conversion\
• “SetupFileConverter.exe”
<program folder>\Agilent\B1500\EasyEXPERT\IC-CAP Support\MDM\
• “MdmFileConverter.exe”
Prober Control
The <program folder>\Agilent\B1500\EasyEXPERT\Utilities\ProberControl folder
stores the execution files used to control the following probers.
• Cascade Microtech Summit 12K or S300
• SUSS MicroTec PA200 or PA300
• Vector Semiconductor VX-2000 or VX-3000
You can use the execution files when you perform a repeat measurement by using
EasyEXPERT and a prober listed above. The execution files control the prober
chuck movement (down, move, and up) by defining them in the Repeat
Measurement Setup window. See “Remote Measurement Setup” in Chapter 1,
User’s Guide Vol. 1. Also see the readme.mht file in the ProberControl folder to use
the prober control script.
This folder also stores the source files and the document files. See the pdf files in the
ProberControl\xxxx\doc folder for more details or if you create your own prober
control script by referring to the source code; xxxx is cascade, suss, or vector.