User`s guide

10-18 Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1
Error Message
Agilent EasyEXPERT Operation Error
112024 At least one SPGU must be used for SPGU Control.
112051 Auto analysis operation failed.
112052 Invalid value A specified for the switching matrix input setting. Specify
a string, string variable, or module variable defined in the test definition
or test setup.
112053 Enter a value for numeric variable A, used to specify the switching
matrix output channel.
112054 A switch setup named A is already in the preset group B. The switch
setup name must be unique in a preset group.
112055 A preset group named A already exists. The preset group name must be
unique.
112056 Enter a name for the switching matrix setup.
112057 Maximum length for a switching matrix setup name is A characters.
112058 Read Switch Setup operation failed. Set the switching matrix
configuration mode to Normal. Could not read the setup for connecting
multiple input ports to a output channel.
112060 Specified connection pattern is not available for the couple port A, B.
112061 Input port A uses a shared path. The path is currently connected to the
other input port. The specified connection is not available.
112071 Invalid Unit value was entered in the Channel Definition area. A test
setup cannot use multiple units connected to the SCUU. Invalid entry:
Unit=SMU A
112072 Invalid value A was specified for Enable/Disable of I/V-t Sampling
Stop Condition. Valid option(s): B
112073 Invalid value A was specified for Name of I/V-t Sampling Stop
Condition. Valid option(s): B
112074 Invalid value A was specified for Event of I/V-t Sampling Stop
Condition. Valid option(s): B
112075 Invalid function was used in the definition of variable specified by
Name of I/V-t Sampling Stop Condition.
112100 ALWG waveform data for A was not found. Set data of the
ALWaveform type parameter properly.
112101 Multiple ALWG waveform data are specified for A. Set Properties of
the ALWaveform type parameter properly.