User`s guide

Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1 10-15
Error Message
Agilent EasyEXPERT Operation Error
108010 The request to load or create Profile was rejected. Profile is already
active. Restart Agilent B1500. If the problem still occurs, contact your
nearest Agilent Technologies.
108011 Invalid Function Module for this EasyEXPERT revision. Module ID:
A, Path:
B
Restart Agilent B1500. If the problem still occurs, contact your nearest
Agilent Technologies.
108020 An I/O error occurred during Function Library operation. Path: A
Restart Agilent B1500. If the problem still occurs, contact your nearest
Agilent Technologies.
108021 Function Module read error. Path: A
Restart Agilent B1500. If the problem still occurs, contact your nearest
Agilent Technologies.
108022 Function Module save error. Path: A
Restart Agilent B1500. If the problem still occurs, contact your nearest
Agilent Technologies.
109001 Auto calibration is in progress.
109002 CMU phase compensation failed.
109011 CMU open correction failed.
109012 The value of standard for CMU open correction must be finite as
admittance.
109021 CMU short correction failed.
109022 The value of standard for CMU short correction must be finite as
impedance.
109031 CMU load correction failed.
109032 The value of standard for CMU load correction must be finite in
impedance (non-zero as admittance).
109041 Cannot define multiple standby settings for a SMU. Channel: A
109051 Direct Control execution status. Sweep measurement was aborted by
the automatic abort function or the power compliance. Test setup: A
109052 Direct Control execution status. Quasi-static CV measurement was
aborted by the automatic abort function. Test setup: A