User`s guide

10-10 Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1
Error Message
Agilent EasyEXPERT Operation Error
105914 Improper number of Arguments for the A command. Enter the
Arguments correctly.
105915 A pulse base must be between B A and C A.
105916 A pulse peak must be between B A and C A.
105917 A pulse peak and base must be between B V and C V.
105918 A compliance must be between B V and C V.
105919 A compliance must be between B A and C A.
105920 A pulse peak  compliance exceeds its output power limit. Compliance
must be between B V and C V.
105921 A pulse peak  compliance exceeds its output power limit. Compliance
must be between B A and C A.
105922 A pulse delay time must be between B s and C s.
105923 A does not support pulse delay time. It must be 0.
105924 SMU pulse measurement delay time must be between A s and B s.
105925 SMU pulse averaging count must be between A and B.
105926 A pulse duty cycle must be B % or less if the pulse peak or compliance
exceeds C A.
105927 A pulse width must be between B s and C s if the pulse peak or
compliance exceeds D A.
105928 A pulse base must be between B A and C A if the pulse peak exceeds D
A.
105929 A pulse peak and base must be same polarity if the pulse output exceeds
B V.
105930 The coefficient for High Speed ADC TIME averaging mode must be
between A s and B s.
105931 Invalid value A was specified for the series resistor of B.
Valid option(s): C
105932 N1258A selector is not found.
105933 Communication with N1258A selector interrupted. Connect the cable
properly.
105934 N1258A selector is turned off. Connect the power cable properly.