User`s guide

6- 4 Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1
Remote Control Interface
Introduction
Supported Operations
The EasyEXPERT remote control interface provides the subsystem commands
listed below. Operations supported by these commands are shown in
Figure 6-2.
• WORKspace Subsystem
Opening/closing workspace
• BENCh Subsystem
Performing test setup and measurement
• RESult Subsystem
Getting test result data
• CALibration Subsystem
Using offset current cancel function
• STANDby Subsystem
Using standby function
• “SYSTem Subsystem”
Checking errors
NOTE To start remote control, the workspace selection screen must be displayed by
EasyEXPERT.