User`s guide

Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1 10-9
Error Message
Agilent EasyEXPERT Operation Error
105843 SPGU cannot be used for bias source of I/V-t linear sampling
measurement of interval < 2 ms.
105844 |Peak-Base| value of PGU pulse must be between A V and B V.
VName: C
105845 Period, Width, and Delay values of PGU pulse must be in the same
setting range. And Leading and trailing values must be in the same
setting range.
105846 SPGU cannot output the specified voltage. Change Load Z value or
output voltage.
105901 Over voltage was applied to SMU measurement terminal.
105902 Over current was applied to SMU measurement terminal.
105903 Cannot use the specified module that failed self-test.
105904 A cannot be set to Additional Data Variables. Only the channels defined
in Channel Definition can be set.
105905 Entry is already defined in Additional Data Variables. It is not
necessary to redefine the entry. Unit: A, Type: B
105906 Variable name specified in Additional Data Variables is used for
another variable. Specify a different name. Variable name: A
105907 FMT command’s first argument must be 13.
105908 Invalid Type value was found in the Additional Data Variables area. A
test setup cannot contain both the type Re(Z) or Im(Z) and the type
Re(Y) or Im(Y).
105909 Program memory number is out of range. Valid value: A to B Entered
value: C
105910 Program memory variable number is out of range. Valid value: A to B
Entered value: C
105911 Empty Command field was found in the Command Setup. A command
must be entered in the Command field.
105912 Test execution error was detected. Check the parameter values of the
command, and set the Arguments field again. Setup
Name=A, Line
Number=B, Command=C
105913 Incorrect usage of ST and END commands. Use them as a pair to store
a command group into the program memory.