User`s guide

Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1 10-7
Error Message
Agilent EasyEXPERT Operation Error
105077 Invalid value A specified for I/V-t sampling output sequence.
Valid
option(s): B
105078 Sampling interval for I/V-t A sampling must be between B s and C s.
105079 Hold time for I/V-t A sampling must be between B s and C s.
105080 Hold time for I/V-t A sampling with interval of B s or longer must be
between
C s and D s.
105081 Hold time for I/V-t A sampling with interval shorter than B s must be
between
C s and D s.
105083 The number of VAR1 steps multiplied by the number of VAR2 steps
must be between A and B in I/V Sweep, I/V List Sweep and Multi
Channel I/V Sweep.
105091 List length of VAR1 sweep must be between A and B for the I/V List
Sweep measurement. Length C is not applicable.
105092 List length of VAR2 sweep must be between A and B for the I/V List
Sweep measurement. Length C is not applicable.
105093 List length of delay time must be between A and B for the I/V List
Sweep measurement. Length C is not applicable.
105094 Time until the first step measurement, (hold time + delay time), must be
between A and B s for the I/V List Sweep measurement using SMU
pulse.
105095 A does not support current measurement.
105801 Invalid value A specified for Output Value after Measurement in the
Advanced Setup dialog box. Valid
option(s): B
105802 Invalid value A specified for Bias Hold after Measurement in the
Advanced Setup dialog box. Valid
option(s): B
105803 Bias hold function execution error. All channel outputs or voltage
compliance must be at the allowable voltage for the interlock open
condition or less to control the output switch or the series resistor.
105804 Bias hold function execution error. Output voltage or voltage
compliance must be
 40 V or less to control the output switch or the
series resistor.
105811 Invalid value A was specified for Semiconductor Relays (B) of
Advanced Setup. Valid option(s): C