User`s guide

10-6 Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1
Error Message
Agilent EasyEXPERT Operation Error
105052 Invalid value (A) was specified for the sweep stop condition. Valid
option(s): B
105053 Invalid value (A) was specified for the impedance measurement model.
Valid option(s): B
105054 Hold time value must be between A s and B s.
105055 Delay time value must be between A s and B s.
105056 Voltage source value of A must be between B V and C V.
105057 Frequency value of A must be between B Hz and C Hz.
105058 Coefficient value of A integral mode must be between B and C.
105059 AC Level value of A must be between B mV and C mV.
105060 Invalid value (B) was specified for monitor ranging mode of A. Valid
option(s): C
105061 SMU pulse period must be A s longer than the pulse width.
105062 Primary sweep source step value must be greater than the setup
resolution.
105063 Synchronous sweep source step value must be greater than the setup
resolution. Adjust the offset value and the ratio value, or change the
primary sweep source settings.
105064 Compliance absolute value must be A A or greater if the channel is the
SMU pulse source and the output value is B Vpp.
105065 Compliance value must be  2 V or less if the channel is the SMU pulse
source and the output value is 0 A to 10 A.
105066 Current compliance must be 100 mA for VSU.
105067 Power compliance must be OFF for VSU.
105071 Sampling interval for I/V-t sampling must be between A s and B s.
105072 Number of samples for I/V-t A sampling must be between B and C.
105073 Hold time for I/V-t sampling must be between A s and B s.
105074 Multiplying the number of monitor channels by No of Samples must be
between A and B.
105075 Invalid value A specified for I/V-t sampling Lin/Log setting.
Valid
option(s): B
105076 Base hold time for I/V-t sampling must be between A s and B s.