User`s guide

10-4 Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1
Error Message
Agilent EasyEXPERT Operation Error
105006 Source wait time coefficient must be between A and B.
105008 Monitor wait time coefficient must be between A and B.
105010 Series resistor is not available for HPSMU using the 1 A range.
105011 I/V Staircase Sweep needs at least one monitoring channel.
105012 I/V Pulsed Sweep needs exactly one monitoring channel.
105013 I/V Sweep with pulsed bias needs exactly one monitoring channel.
105014 I/V-t Sampling needs at least one monitoring channel.
105015 C-V Sweep needs at least one monitoring channel.
105016 At least one measurement channel is required for Multi Channel I/V
Sweep measurement.
105017 Only one measurement channel can be used for I/V-t linear sampling
measurement of interval < 2 ms.
105018 Base hold time is not available for 4155B/C and 4156B/C. The value
must be 0.
105020 Interlock circuit is open. Interlock circuit must be closed to set an
output or compliance value greater than
 40 V.
105021 Current source value of A must be between B A and C A.
105022 Voltage compliance value of A must be between B V and C V.
105023 Voltage source value of A must be between B V and C V.
105024 Current compliance value of A must be between B A and C A.
105025 Power compliance value of A must be between B W and C W.
105026 A power compliance must be OFF.
105027 Measurement unit emergency reset occurred.
Code: A 
Reason: B
105031 The product of voltage source value and current compliance value of A
exceeds its output power range. Please set the current compliance value
between B A and C A.
105032 The product of current source value and voltage compliance value of A
exceeds its output power range. Please set the voltage compliance value
between B V and C V.