User`s guide

9-18 Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1
If You Have a Problem
B1500 System Recovery
B1500 System Recovery
If you find problems in the B1500 system, perform the system recovery.
• “Preparation”
• “To Perform System Recovery”
• “To Initialize Database”
• “To Restore Database”
Preparation
1. Note the computer name of your B1500.
This is required to set the same computer name again after System Recovery is
completed. You can find it on System Properties displayed by Control Panel >
System.
2. Note all user account if you added the accounts.
This is required to add the same user accounts again after System Recovery is
completed. You can check it on User Accounts displayed by Control Panel >
User Accounts.
3. Make backup of data in the HDD. See “Data Backup and Recovery” on page
9-14.
To Perform System Recovery
B1500 system recovery can be performed by the following procedure.
1. Set the B1500 Standby switch to the OFF position.
2. Disconnect all USB devices from the B1500.
3. Connect the USB keyboard to a USB port of the B1500.
4. Set the B1500 Standby switch to the ON position.
5. Before Windows boots up, press the F8 key to display the boot system selection
menu.