User`s manual

76 Agilent E8462A Relay Multiplexer Command Reference
DIAGnostic:INTerrupt:TIMer
DIAGnostic:INTerrupt:TIMer <card_number>, <time> sets the multiplexer
interrupt timer. The <card_number> parameter specifies which module to set.
Parameters
Comments • The time specified in the command will be rounded to 0.002, 0.005, 0.008 or
0.064 seconds.
Note Setting the interrupt time too small can cause system problems.
• The module’s interrupt timer will be set to the specified value. This is the
amount of time the module will wait after a relay close or open command is
given before sending an interrupt and clearing the “busy” bit.
• *RST does not change the selected time.
Example Delay the interrupt signal 8 mS after a relay is opened or closed.
DIAG:INT:TIM 2,0.008
Interrupt timer on card number 2 is set for
8 mS . Interrupt signal is delayed 8 mS
after an open or close to allow for settling
of relay contacts.
DIAGnostic:INTerrupt:TIMer?
DIAGnostic:INTerrupt:TIMer? <card_number> queries the specified multiplexer
module and returns the interrupt delay time.
Example Query the interrupt timer setting.
DIAG:INT:TIM? 2
Query the interrupt timer setting on card
number 2.
Name Type Range of Values Default
<card_number> numeric 1-99 1
<time> numeric 0.002 - 0.064
(0.002, 0.005, 0.008 or 0.064)
0.005 seconds