User`s manual

52 Using the Multiplexer
Recalling and Saving States
This section contains information about saving and recalling a Multiplexer
module state.
Saving States The *SAV <numeric_state> command saves the current instrument state.
The state number (0-9) is specified in the state parameter. The following
settings are saved:
• Channel Relay State (CH000-256 open or closed);
• Tree Relay State (CH9000-9021 open or closed);
• Routing Relay Stare (CH9100-9108 open or closed).
• Analog Bus Connection Control Relay State (CH9200-9204 open or
closed)
• ARM:COUNt Value
• TRIGger:SOURce Mode
• OUTPut[:STATe] Configuration
• INITiate:CONTinuous Mode
• [ROUTe:]FUNCtion Mode
• [ROUTe:]SCAN:MODE Mode
• [ROUTe:]SCAN:PORT Mode
• DIAGnostic:SCAN:DELay Time
• DIAGnostic:INTerrupt[:LINE] Setting
• DIAGnostic:INTerrupt:TIME Time
Recalling States The *RCL <numeric_state> command recalls a previously saved state.
Enter the number (0-9) in the state parameter of the desired saved state. If
*SAV was not previously executed using the selected number, the
Multiplexer will be configured to the reset values (see "Table 2-1. Agilent
E8462A Default Conditions for Power-on and Reset" on page 35).
Note Scan lists are not saved when a state is saved. You must re-enter your scan
list after recalling a state.