User`s manual

38 Using the Multiplexer
Mode: WIRE1 Figure 2-1 shows the 1-Wire mode (configured as a 1 x 256 multiplexer).
• Tree Relays: T0 through T7 are closed to connect the specific channels
to Terminal Bus Ter0 and Ter1.
• Routing Relays: C100 and C108, toggles between the Ter0 and Ter1
terminal bus line to route all channels to Ter0 (1-wire).
• Valid Channel List: All 256 channels (000-255).
• Analog Bus: All the channels can be also connected to analog bus line
H1 by closing AB200 (CH9200) and toggling C108 (CH9108).
• SCPI Example: How to set the mode and close a channel.
FUNC 1, WIRE1
Specify the 1-Wire mode.
CLOS (@10005)
Close channel 5.
Figure 2-1. 1-Wire (1 x 256 Multiplexer) Operating Mode
1-Wire @ Ter0
Description:
one 1-wire x 256 ch MUX
Front Panel Pin-out:
See Figure 1-6