User`s manual

Index 153
Switching or Scanning, 36
Synchronizing the Multiplexer with a Multimeter, 46
SYSTem
CDEScription?, 105
CPON, 106
CTYPe?, 106
ERRor?, 107
SYSTem Subsystem, 105, 105, 106, 106, 107
T
Temperature Measurements By Channel Switching,
43
Terminal Module
wiring a, 26
Terminal Modules, 24
The Device Type Register, 134
The Status/Control Register, 134
The WRITE Registers, 133
Three-wire Mode
query channel closure, 95
Timing
program, 139
Tree Relays
closing, 136
description, 120
opening, 136
reset condition, 118
*TRG, 112, 112
Common (*) Commands
*TRG, 112, 112
Trig In Ports
trigger input, 111, 112
Trig Out Ports
disabling, 84, 84
enabling, 84, 84, 85
query state of, 85
TRIGger
SLOPe, 110
SLOPe?, 111
SOURce, 111, 112, 112, 112
SOURce?, 113
Trigger
bus inputs, 112
external inputs, 111
query source, 113
source, 111
TRIGger Subsystem, 110, 110, 110, 111, 111, 112,
112, 112, 113
TRIGger[[:IMMediate]], 110
TTL Trigger
enabling and setting, 85, 111, 112
query state of, 86
Two-wire Ohms Scanning Measurements, 98
Two-wire Resistance Measurements
scanning voltmeter, 121
Types
error, 145
U
User Inputs
connecting, 18
Using a Multimeter with the Multiplexer, 140
Using BUS Triggers with an External Device to Scan
Channels
, 51
Using Interrupts With Error Checking, 53
V
Variable SCPI Command Syntax, 69
Volt Mode Scanning Measurements, 98
Voltage
measurements, 121
Voltage Sense Bus
tree relay channel, 120
W
Wiring a Terminal Module, 26
Writing to Registers, 129