User`s manual

126 Agilent E8462A Specifications
Input Characteristics
These limits apply only if there are no connections made to power mains.
Maximum Input
NOTES:
a. Limited to 15,000 hours of voltage stress above 180V ACrms/DC (254Vpeak).
b. Replace the Crimp and Insert connector after 15,000 hours of operation of switching over
180V ACrms or 180Vdc. Refer to Chapter 1 of this manual.
c. Rating reduced to 30V ACrms, 42V ACpeak for exposed conductors.
Caution When using the Option 012 Terminal Block:
The front panel connectors on the Agilent E8462A module must
be replaced after 15,000 hours of >180Vrms voltage stress due
to the close terminal spacing and the potential for pin-to-pin
leakage if the module regularly switches voltages greater
than 180VDC, 180VACrms or 254VACpeak/transient.
Caution When using the Option 014 or Option 015 Terminal Block:
The ribbon cable header connectors on the Agilent E8462A
Option 014 or Option 015 Terminal Card must be replaced after
15,000 hours of >50Vrms voltage stress due to the close
terminal spacing and the potential for pin-to-pin leakage if the
module regularly switches voltages greater than 60VDC,
50VACrms, or 70.7 VACpeak.
DC Performance
(Typical)
Thermal offset per Channel: 1-wire = ±3V
2-wire = ±1.5V
Closed Channel Resistance, 1-wire:  with output protection resistor
shorted; protection resistor adds 100.
With Option 012
Crimp & Insert
Terminal Card
With Opt. 014
Fault Tolerant
Terminal Card
With Opt. 015
Ribbon Cable Conn.
Terminal Card
Analog Bus
Maximum DC Voltage 250 V
(see notes a and b)
60 V 60 V 60 V
Max. ACrms Voltage 250 V
(see notes a and b)
50 V
(see note c)
50 V
(see note c
30 V
Max. ACpeak Voltage 353V
(see note a)
70.7 V
(see note c)
70.7 V
(see note c)
42 V
Transient Voltage 1500 V - - -
Maximum Current per Channel:
Switching:
Carry:
2A @ 30V
2A
100 mA
100 mA
100 mA
100 mA
N/A
N/A