User`s manual

Agilent E8462A Relay Multiplexer Command Reference 103
STATus:OPERation:CONDition?
STATus:OPERation:CONDition? Returns the state of the Condition Register in the
Operation Status Group. The state represents conditions which are part of the
instrument's operation. The "SWITCH" driver does not set bit 8 in this register (see
STATus:OPERation[:EVENt]? on page 103).
STATus:OPERation:ENABle
STATus:OPERation:ENABle <number> Sets an enable mask to allow events
recorded in the Event Register to send a summary bit to the Status Byte Register
(bit 7). For multiplexer modules, when bit 8 in the Operation Status Register is set
to 1 and that bit is enabled by the
STATus:OPERation:ENABle command, bit 7 in the
Status Register is set to 1.
Parameters
Comments Setting Bit 7 of the Status Register: STATus:OPERation:ENABle 256 sets bit 7 of
the Status Register to 1 after bit 8 of the Operation Status Register is set to 1.
Related Commands:
[ROUTe:]SCAN
Example Enabling the Status Register
STAT:OPER:ENAB 256
Enables bit 8 of the Operation Status
Register to be reported to bit 7 (OPR) in
the Status Register.
STATus:OPERation:ENABle?
STATus:OPERation:ENABle? Returns which bits in the Event Register (Operation
Status Group) are unmasked.
STATus:OPERation[:EVENt]?
STATus:OPERation[:EVENt]? Returns which bits in the Event Register (Operation
Status Group) are set. The Event Register indicates when there has been a
time-related instrument event.
Comments Setting Bit 8 of the Operation Status Register: Bit 8 (scan complete) is set to 1
after a scanning cycle completes. Bit 8 returns to 0 (zero) after sending the
STATus:OPERation[:EVENt]? command.
Parameter
Name
Parameter
Type Range of Values
Default
Value
number
numeric 1 through 65,535 N/A