Technical data

Agilent E7501A Getting Started 3-45
Using SCPI Interfaces
Using the E7501A SCPI Interface
Using a Remote PC such as Unix
1. From a Unix prompt, type: telnet <IP address>,
where, <IP address> is the IP address of the PC that is running the
opened E7501A SCPI interface. (In the previous section, “Enabling a
Telnet Connection” on page 3-42, the IP address was 141.121.82.18, but
the PC being connected to in your situation would be different.)
The telnet program must be installed and available on your Unix station.
If it is available, a dialog box similar to the following might appear that
allows you to enter SCPI commands.
2. Enter the SCPI command,
*IDN?
If everything is working correctly with the Telnet connection, you
should see a response such as the following: