Technical data

3-44 Agilent E7501A Getting Started
Using SCPI Interfaces
Using the E7501A SCPI Interface
Examples Using a
Telnet Connection
The Telnet program can be running on either the same local PC or a
remote PC that is also running the E7501A SCPI interface with a Telnet
connection enabled.
Using the Same Local PC
1. Select Start/Run and type telnet.
The telnetprogram must be installed and available on your local PC. If
it is available, a dialog box similar to the following might appear that
allows you to enter SCPI commands. The IP address of your local PC
couldalsobeusedinplaceoflocalhost.
2. Enter the SCPI command,
*IDN?
If everything is working correctly with the Telnet connection, you
should see a response such as the following: