Technical data

Agilent E7501A Getting Started 3-41
Using SCPI Interfaces
Using the E7501A SCPI Interface
3. Select the Enable check box for the type of connection being made.
You may select one, two, three, or four of the Enable check-boxes.
Checking all four Enable check-boxes gives access to the settings used
for each connection. (When selecting the VXI-11 enable checkbox, refer
to, “Configuring a VXI-11 Connection” on page 3-29.)
Refer to the following procedures when enabling a connection:
“Enabling a Telnet Connection” on page 3-42
“Enabling a Sockets Connection” on page 3-46
“Enabling an RS-232 Connection” on page 3-48
4. Click the OK button when finished editing the connection settings.
The selected connections are opened to the Agilent E7501A arbitrary
analog signal development system.
5. Start the external programming application software being used (such as
VEE or C++). For further information, refer to “Examples Using a
Telnet Connection” on page 3-44
6. Send/Type the desired E7501A SCPI commands between the external
programming application software, through the enabled connection, to
the Agilent E7501A arbitrary analog signal development system.
(For a complete list of available SCPI commands, refer to E7501A SCPI
Commands in the Online Help.)