Technical data

3-40 Agilent E7501A Getting Started
Using SCPI Interfaces
Using the E7501A SCPI Interface
Configuring a Telnet,
Sockets, or RS-232
Connection
Overview of Steps:
• Start the E7501A SCPI Interface.
• Select a configuration (Agilent E7501A or Demo).
• Select the Enable check box for the type of connection being made.
• Start the external programming application software.
• Send SCPI commands.
Configuring a Telnet, Sockets, or RS-232 connection may require the
following procedures:
1. Start the E7501A SCPI Interface.
Click the Start menu,
point to Programs,
point to Agilent Signal Studio,
point to E7501A Signal Development System,
point to and click E7501A SCPI Interface.
2. Select the configuration that you would like to use:
Agilent E7501A or Demo. The Agilent E7501A configuration requires
system hardware while the Demo configuration is used for operating
without system hardware.